Dell S6000 Reference Manual page 630

vrrp [[ipv6] vrid]
learning-limit
Defaults Without an interface specified, the command clears all interface counters.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.5.1.0
Version 8.4.1.0
Version 8.3.7.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.5.1.0
Example
Dell#clear counters
Clear counters on all interfaces [confirm]
630
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigE then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a tunnel interface, enter the keyword tunnel. The
range is from 1 to 16383.
(OPTIONAL) Enter the keyword vrrp to clear the counters of
all VRRP groups. To clear the counters of VRRP groups on all
IPv6 interfaces, enter ipv6. To clear the counters of a
specified group, enter a VRID number from 1 to 255.
(OPTIONAL) Enter the keywords learning-limit to clear
unknown source address (SA) drop counters when MAC
learning limit is configured on the interface.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Added support (E-Series only) for VRRP groups in a VRF
instance.
Introduced on the S4810.
Added support for 4093 VLANs on the E-Series ExaScale.
Prior to the release, 2094 was supported.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Updated the definition of the learning-limit option for
clarity.
Interfaces