Gpon Device Access And Login - ZyXEL Communications PMG5317-T20A User Manual

If the problem continues, contact the vendor.
5

37.2 GPON Device Access and Login

I forgot the IP address for the GPON Device.
The default LAN IP address is 192.168.1.1.
1
If you changed the IP address and have forgotten it, you might get the IP address of the GPON
2
Device by looking up the IP address of the default gateway for your computer. To do this in most
Windows computers, click Start > Run, enter cmd, and then enter ipconfig. The IP address of the
Default Gateway might be the IP address of the GPON Device (it depends on the network), so
enter this IP address in your Internet browser.
If this does not work, you have to reset the device to its factory defaults. See
3
21.
I forgot the password.
See the cover page for the default login names and associated passwords.
1
If those do not work, you have to reset the device to its factory defaults. See
2
21.
I cannot see or access the Login screen in the web configurator.
Make sure you are using the correct IP address.
1
• The default IP address is 192.168.1.1.
• If you changed the IP address
• If you changed the IP address and have forgotten it, see the troubleshooting suggestions for
forgot the IP address for the GPON Device.
Check the hardware connections, and make sure the LEDs are behaving as expected. See
2
1.5 on page
Make sure your Internet browser does not block pop-up windows and has JavaScripts and Java
3
enabled.
If it is possible to log in from another interface, check the service control settings for HTTP and
4
HTTPS (Maintenance > Remote MGMT).
Chapter 37 Troubleshooting
(Section 8.2 on page
19.
PMG5317-T20A User's Guide
112), use the new IP address.
272
Section 1.6 on page
Section 1.6 on page
I
Section