Table of Contents
Advertisement
When a UPnP device joins a network, it announces its presence with a multicast message. For
security reasons, the GPON Device allows multicast messages on the LAN only.
All UPnP-enabled devices may communicate freely with each other without additional configuration.
Disable UPnP if this is not your intention.
UPnP and ZyXEL
ZyXEL has achieved UPnP certification from the Universal Plug and Play Forum UPnP™
Implementers Corp. (UIC). ZyXEL's UPnP implementation supports Internet Gateway Device (IGD)
1.0.
See
Section 8.4.1 on page 118
Finding Out More
See
Section 8.7 on page 121
8.1.3 Before You Begin
Find out the MAC addresses of your network devices if you intend to add them to the DHCP Client
List screen.
8.2 The LAN Setup Screen
Use this screen to set the Local Area Network IP address and subnet mask of your GPON Device.
Click Network Setting > Home Networking to open the LAN Setup screen.
Follow these steps to configure your LAN settings.
Enter an IP address into the IP Address field. The IP address must be in dotted decimal notation.
1
This will become the IP address of your GPON Device.
Enter the IP subnet mask into the Subnet Mask field. Unless instructed otherwise it is best to leave
2
this alone, the configurator will automatically compute a subnet mask based upon the IP address
you entered.
Chapter 8 Home Networking
for examples of installing and using UPnP.
for technical background information on LANs.
PMG5317-T20A User's Guide
112
Advertisement
Table of Contents
