Grandstream Networks UCM6200 User Manual page 52
Ip pbx
Hide thumbs
Also See for UCM6200:
- User manual (469 pages) ,
- Basic configuration manual (26 pages) ,
- Manual (28 pages)
Table of Contents
Advertisement
Value
LAN 1 / LAN 2 (when Method is set to "Dual")
If "Dual" is selected as "Method", users will need assign the default interface to be LAN 1
Default
(mapped to UCM6202 WAN port) or LAN 2 (mapped to UCM6202 LAN port) and then
Interface
configure network settings for LAN 1/LAN 2. The default interface is LAN 2.
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
IP Method
IP Address
Enter the IP address for static IP settings. The default setting is 192.168.0.160.
Subnet Mask
Enter the subnet mask address for static IP settings. The default setting is 255.255.0.0.
Enter the gateway IP address for static IP settings when the port is assigned as default
Gateway IP
interface. The default setting is 0.0.0.0.
DNS Server 1
Enter the DNS server 1 address for static IP settings. The default setting is 0.0.0.0.
DNS Server 2
Enter the DNS server 2 address for static IP settings.
User Name
Enter the user name to connect via PPPoE.
Enter the password to connect via PPPoE.
Password
Layer 2 QoS
802.1Q/VLAN
Assign the VLAN tag of the layer 2 QoS packets for LAN port. The default value is 0.
Tag
Layer 2 QoS
802.1p Priority
Assign the priority value of the layer 2 QoS packets for LAN port. The default value is 0.
Value
IPv6 Address
WAN (when "Method" is set to "Route")
IP Method
Select Auto or Static. The default setting is Auto
IP Address
Enter the IP address for static IP settings.
IP Prefixlen
Enter the Prefix length for static settings. Default is 64
DNS Server 1
Enter the DNS server 1 address for static settings.
DNS Server 2
Enter the DNS server 2 address for static settings.
LAN (when Method is set to "Route")
Select Disable, Auto or DHCPv6.
Disable: the DHCPv6 server is disabled.
DHCP Server
Auto: Stateless address auto configuration using NDP protocol.
DHCPv6: Stateful address auto configuration using DHCPv6 protocol.
DHCP Prefix
Enter DHCP prefix. (Default is 2001:db8:2:2::)
DHCP
Enter the Prefix length for static settings. Default is 64
prefixlen
Enter the DNS server 1 address for static settings. Default is (2001:4860:4860::8888 )
DNS Server 1
DNS Server 2
Enter the DNS server 2 address for static settings. Default is (2001:4860:4860::8844 )
UCM6200 Series User Manual
P a g e
|
51
Advertisement
Table of Contents
Troubleshooting
