The Wps Screen - ZyXEL Communications XMG3512-B10A User Manual

Use this screen to view your XMG's MAC filter settings and add new MAC filter rules. Click Network
Setting > Wireless > MAC Authentication. The screen appears as shown.
Figure 38 Wireless > MAC Authentication
The following table describes the labels in this screen.
Table 23 Wireless > MAC Authentication
LABEL
SSID
MAC Restrict
Mode
Add new MAC
address
#
MAC Address
Modify
Apply
Cancel

7.5 The WPS Screen

Use this screen to configure WiFi Protected Setup (WPS) on your XMG.
WPS allows you to quickly set up a wireless network with strong security, without having to configure
security settings manually. Set up each WPS connection between two devices. Both devices must
support WPS. See
Chapter 7 Wireless
DESCRIPTION
Select the SSID for which you want to configure MAC filter settings.
Define the filter action for the list of MAC addresses in the MAC Address table.
Select Disable to turn off MAC filtering.
Select Deny to block access to the XMG. MAC addresses not listed will be allowed to access the
XMG.
Select Allow to permit access to the XMG. MAC addresses not listed will be denied access to the
XMG.
Click this if you want to add a new MAC address entry to the MAC filter list below.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the XMG
in these address fields. Enter the MAC addresses in a valid MAC address format, that is, six
hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
This is the index number of the entry.
This is the MAC addresses of the wireless devices that are allowed or denied access to the XMG.
Click the Edit icon and type the MAC address of the peer device in a valid MAC address format
(six hexadecimal character pairs, for example 12:34:56:78:9a:bc).
Click the Delete icon to delete the entry.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Section 7.9.8.3 on page 106
XMG3512-B10A User's Guide
for more information about WPS.
93