Table of Contents
Advertisement
The following table describes the fields in this screen.
Table 10 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL/VDSL over PTM -Bridge or
Ethernet Mode)
LABEL
DESCRIPTION
General
Name
Enter a service name of the connection.
Type
Select ADSL/VDSL over PTM as the interface that you want to configure. The XMG uses the VDSL
technology for data transmission over the DSL port.
Mode
Select Bridge when your ISP provides you more than one IP address and you want the connected
computers to get individual IP address from ISP's DHCP server directly. If you select Bridge, you
cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on traffic from the
selected LAN port(s).
VLAN
This section is available only when you select ADSL/VDSL over PTM in the Type field.
Active
Select Enable to enable VLAN on this WAN interface.
802.1p
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that
contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater
the number, the higher the priority level.
802.1q
Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
OK
Click OK to save your changes.
Cancel
Click Cancel to exit this screen without saving.
If you select ADSL over ATM as the interface type, the following screen appears.
Figure 26 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL over ATM-Bridge Mode)
The following table describes the fields in this screen.
Table 11 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL over ATM-Bridge Mode)
LABEL
DESCRIPTION
General
Name
Enter a service name of the connection.
Chapter 6 Broadband
XMG3512-B10A User's Guide
72
- Quick Links:
- Introducing the Xmg
Hide quick links:
Advertisement
Table of Contents
