Stereo Link; Copy/Paste & Preset Load/Save - PRESONUS studiolive III series Owner's Manual

5 The Fat Channel
5.7

Stereo Link

Stereo Link
5.7
5.8 Copy/Paste & Preset Load/Save
When a channel or mix is selected, pressing this button links some of the parameters
of a channel or mix with those of its even or odd counterpart (channel 1 links only
with 2, 7 links with 8, and so on). When this button is lit, the selected channel is linked
to its paired channel. The following parameters are always kept in parity between
linked channels or buses:
• Input assignment
• Channel type
• Bus mode (aux/subgroup)
• Compressor/EQ type
• Gate parameters & keying (signal from either channel or mix can trigger both
related gates)
• EQ parameters
• Graphic EQ settings
• Mute and Solo states
• Bus assignments
• Phantom power and polarity status
• Fat Channel EQ/Dyn A/B status
• Aux and FX send levels
• Pan position
• Filter DCA group assignment
• Talkback and monitor routing settings
• Pre/post fader settings
• Bus output delay
Some parameters have configurable linking behavior that allow them to work in
tandem (stereo linked) or be independently set. This is configured in the Channel
Settings screen in the Master Control section:
• Preamp trim
• Pan settings
• Channel or mix fader levels
• Compressor and limiter keying
• Channel/bus names
For more information on selecting linking options, see Section 5.1.1.1.
Press Copy to copy Fat Channel settings from the currently selected channel to one
or more other channels. Once Copy is pressed, the Select buttons for all other
channels start blinking. Press the Select button on any channels to which you want
to copy Fat Channel settings from the currently selected channel.
Press Load to paste the settings to the selected channels.
The Save and Load buttons let you save and load Fat Channel presets, letting you
store and reapply useful Fat Channel processing and utility settings to future mixes.
While all Fat Channel settings are included when you save a preset, you can choose
to filter out some types of settings, to load only part of a preset (such as only EQ and
compressor parameters).
StudioLive™ Series III
Owner's Manual
54