Tape Controls; Pairing A Bluetooth Device - PRESONUS studiolive III series Owner's Manual

6

Tape Controls

6.1

Pairing a Bluetooth Device

6 Tape Controls
6.1 Pairing a Bluetooth Device
By default, the Tape channel is sourced from the analog Tape In jacks on the rear
of the mixer and the currently paired Bluetooth audio device simultaneously.
The two signals are mixed together and summed on the Tape In channel.
If you prefer, you can instead route audio from a connected network device,
computer connected via USB, or from audio files stored on an inserted SD card.
To configure the tape input options, press the Edit button in the Tape control area,
next to the touchscreen.
The Tape Edit screen is displayed. Here, you can choose a signal to be routed to the
Tape input channel from the following options:
• Analog/BT. Touch this button to route both the Tape input jacks and the currently
selected paired Bluetooth device to the Tape input channel. When selected, two
slots are shown for paired Bluetooth devices. Touch the button that relates to your
choice of device to route its audio output to the Tape input channel. Each device
also has a Remove Device button, which lets you break the pairing connection to
that device, allowing you to pair another device, or to work out pairing issues with
a device that doesn't seem to function.
• Network. Touch this button to route audio from the designated "Tape" channel of
a connected network device to the Tape input channel. For more information on
networked audio routing, see Section 8.1.5.2.
• USB. Touch this button to route audio from a USB-connected computer to the
Tape input channel. Once selected, you will have the choice of channels 1/2 or
37/38 from the USB stream. For more information on USB audio routing,
see Section 8.1.5.3.
• SD Card. Touch this button to route audio residing on an inserted SD card to the
Tape input channel.
The Tape to Main knob mirrors the setting of the Tape input channel fader. Touch the
knob to adjust this setting with the Master Control encoder.
To pair a Bluetooth audio device for use with the Tape input:
• Press and hold the Bluetooth button in the Tape control area for two seconds
to enter pairing mode.
• The button flashes while StudioLive searches for a discoverable Bluetooth
device with which to pair.
• Once the device is paired, the Bluetooth button glows steadily.
Note that while up to two Bluetooth devices can be paired at one time, only one device
can input audio at a time.
StudioLive™ Series III
Owner's Manual
57