PRESONUS studiolive III series Owner's Manual page 51

5 The Fat Channel
5.1 Fat Channel Navigation
5.1.4.2 Passive Program EQ
3. Q. Sets the Q for the currently selected band (Call-out #5, 7, 9, or 11).
4. Input Meter. Displays the Input signal to the EQ.
5. Band 1 Select. Selects Band 1 for control via Gain (#1), Frequency (#2),
and Q (#3).
6. Band 1 On/Off. Enables/disables Band 1.
7. Band 2 Select. Selects Band 2 for control via Gain (#1), Frequency (#2),
and Q (#3).
8. Band 2 On/Off. Enables/disables Band 2.
9. Band 3 Select. Selects Band 3 for control via Gain (#1), Frequency (#2),
and Q (#3).
10. Band 3 On/Off. Enables/disables Band 3.
11. Band 4 Select. Selects Band 4 for control via Gain (#1), Frequency (#2),
and Q (#3).
12. Band 4 On/Off. Enables/disables Band 4.
Note: When one of the output buses is selected, Bands 5 and 6 will also be visible.
13. Output Meter. Displays the post-EQ Output signal.
14. High Shelf On/Off. Enables/disables the high shelf EQ. When the Shelf button is
not engaged, the High band is a parametric EQ. Enabling the Shelf button turns
the High band into a high shelving EQ that alters, by a fixed amount, a band of
high frequencies at and above a user-selected shelving frequency.
Power User Tip: A high shelving EQ is like a treble-control knob on a stereo. In this mode,
the Center Frequency control selects the shelving frequency.
15. Low Shelf On/Off. Enables/disables the low shelf EQ. When the Shelf button is
not engaged, the Low band is parametric. Enabling the Shelf button turns the
Low band into a low-shelving EQ that alters, by a fixed amount, a band of low
frequencies at and below a user-selected shelving frequency.
Power User Tip: A low shelving EQ is like a bass-control knob on a stereo. In this mode, the
Center Frequency control selects the shelving frequency.
16. RTA. Engages/disengages the RTA display in the EQ graph.
17. EQ On/Off. Globally switches all EQ bands On or Off.
When the Passive EQ is selected, the following controls are available in the
Fat Channel:
1 2 3
LOW LOW LOW
Boost Atten Freq
0.00 0.00 30 Hz
1. Low Boost. Sets the level of boost applied around the chosen low frequency.
This control interacts nicely with the Low Attenuation control, allowing for
boosts in apparent bass energy while keeping overall bass energy within
optimal limits.
2. Low Attenuation. Sets the level of attenuation applied around the chosen low
frequency. This control interacts nicely with the Low Boost control, allowing
for boosts in apparent bass energy while keeping overall bass energy within
optimal limits.
3. Low Frequency Select. Sets the center frequency of the band covered by the
Low Boost and Low Attenuation controls.
4 5 6 7
HIGH
HIGH HIGH HIGH
Boost Bndwdth Freq Atten
0.02 0.06 5 kHz 0.00
StudioLive™ Series III
Owner's Manual
8
ATTN
Select
10 kHz
47