Top Panel Connections - PRESONUS studiolive III series Owner's Manual

3 Hookup
3.2

Top Panel Connections

3.2 Top Panel Connections
Power Input. Connect the provided IEC power cable to this input.
Power Switch. Push the top part of this switch to power your StudioLive on, and the
bottom to switch power off.
Lamp Connector. This 12V BNC connection is provided to connect a third-party
console lamp. Do not use a bulb that is larger than 12V, 380 mA.
SD Card Slot. This slot accepts standard-sized SD cards at capacities up to 32 GB
(SDHC supported). SD cards can be used for audio recording and playback,
storage and recall of mixer settings, and firmware updates.
Headphone Output. On the front of the StudioLive, a 1/4-inch TRS jack is available
for connecting a pair of headphones. Headphone output level is set by turning the
Phones knob in the Monitors section of the mixer. By default, this output receives its
signal from the solo bus, but you can freely assign any mix bus (pre-or-post-fader),
USB Digital Return, or audio network input to the Headphone output. See Section 9
for more information.
StudioLive™ Series III
Owner's Manual
13