System Data; Gas Connection; High Elevation; Gas Pipe Pressure Testing - Regency C34 Classic Owners & Installation Manual

installation
|
28

SYSTEM DATA

(For 0 to 4,500 feet altitude)
Burner
Burner
Max. Input Rating
Min. Input Rating
Supply Pressure
Manifold Pressure High
Manifold Pressure Low
Output capacity:
under continuous operating conditions and
was determined independently of any installed
system.
28 |
Regency CLASSIC™ C34-10 Direct Vent Freestanding Gas Stove
®

GAS CONNECTION

pipe is supplied separately and must be installed
section for diagram. The gas line can be rigid pipe
local codes, or copper if approved. For minimum
Data table.
Note: During any pressure testing of the gas
pressures of 1/2 psig, this appliance

HIGH ELEVATION

This unit is approved in Canada for altitude 0 to
GAS PIPE PRESSURE
TESTING
The appliance must be isolated from the gas sup-
ply piping system by closing its individual manual
supply piping system at test pressures equal to or
The manifold pressure is controlled by a regulator
at the pressure test point.
Note: To properly check gas pressure, both
1.
2.
3.
4.
tion.
5.
the unit burning and the setting should be within
7.
gas valve, disconnect the hose and tighten the
-
-
-