Dura-Vent Horizontal Installations - Regency C34 Classic Owners & Installation Manual

installation
|
24
DURA-VENT
HORIZONTAL
INSTALLATIONS
1.
to determine if wall studs or roof rafters
are in the way when the venting system is
attached. If this is the case, you may want
to adjust the location of the unit.
2.
are designed with special
connect the venting system
tor is installed on the unit at
the factory. Assemble the
desired combination of
pipe and elbows to the
appliance adaptor with
pipe seams oriented to-
wards the wall or ceiling,
as much out of view as
and 90 elbow assembly is determined by
o
the mounting orientation of the adaptor
connection.
Note:
a)
tions, located on the female ends of
straight onto the male ends of adjacent
pipe indentations so they match and
slide in to the four entry slots on the
sections completely
pipe and to outer pipe on every twist-
Diagram 1
b)
ported every three feet. Wall straps are
available for this purpose.
24 |
Regency CLASSIC™ C34-10 Direct Vent Freestanding Gas Stove
®
3. With the pipe attached to the stove, slide
square hole. The center of the square hole
should line up with the center-line of the
Cut and frame the 10 inch square hole
terminated. If the wall being penetrated is
constructed of non-combustible material, i.e.
hole is acceptable.
-
-
Note:
a)
together, then
-
1 foot of run towards the termination.
Never allow the vent to run downward.
This could cause high temperatures
and may present the possibility of a
b)
meet all local and national building
or obstructed. See diagram 10 in
section.
c)
For installations requiring a vertical rise
as shown in Diagram 3 are available,
as well as the standard Riser Vent, see
Diagram 3a. Follow the same installa-
tion procedures as used for standard
-
Diagram 2
4: As specified
in CGA B149 In-
stallation Code.
Local codes or
clearances.
Diagram 3
Note: Riser Vent is
Diagram 3a
Below Grade Installation
below grade, i.e. basement application, proper
drainage must be provided to prevent water
to Diagram 4. Do not attempt to enclose the
the wall, or any
other type of en-
closure.
Diagram 4