Log Installation; Door And Glass Frame - Regency C34 Classic Owners & Installation Manual

installation
|
30

LOG INSTALLATION

WARNING: Dangerous operating con-
Read the instructions below carefully
broken do not use the unit until they are
replaced. Broken logs can interfere with
the pilot and burner operation.
1.
shown.
Diagram 1
DO NOT TRY TO TURN DOOR
HANDLE! IT IS NOT DE-
SIGNED TO BE MOVED.
without the glass in the door, or with
the door open.
2. Remove the glass frame from the stove by
3.
installed.
4.
unwrap them. The logs are fragile, handle
with care. Do not force into position.
5. Place the rear log on the rear log support pins
the log down onto the pins. See diagram 3.
30 |
Regency ® CLASSIC™ C34-10 Direct Vent Freestanding Gas Stove
Hex Nuts
Screws
Diagram 2
6. Place the front log in the front of the unit,
aligning the holes on the underside of the
log with the log support pins in the front of
the unit. Carefully push the log down onto
the pins. See diagram 3.
7. Place the cross logs on top of the larger
logs aligning the holes on the underside of
the cross log with the log pins in the larger
the cross logs onto the pins.
Diagram 3
Diagram 4
8. Distribute the embers along the mesh em-
ber tray but do not cover the burner ports.
turn the unit on as per lighting instructions
9. Separate platinum embers and place on the
mesh ember tray along side embers. Avoid
Door
check the area of hesitation and see
blocking a burner port or ports. If so,
10 Replace the glass. Secure door in the closed
the screw provided, Figure 1. See door and
glass frame instructions.
Note: Door securing bracket is there for
safety.

DOOR AND GLASS FRAME

1. The glass frame fastens with four screws.
See diagram 1.
without the glass in place. (One ex-
2.
Diagram 5
Door
Hex Nuts
Screws
Diagram 1