Dura-Vent Termination Kit - Regency C34 Classic Owners & Installation Manual

DURA-VENT
TERMINATION KIT
Planning Your Dura-Vent
Installation
There are two basic types of Dura-Vent Direct
When planning your installation, it will be nec-
essary to select the proper length of vent pipe
installations, determine the minimum clearance
from the rear of the unit to the wall. It is also
quired between the outer wall of the vent pipe and
the vent termination clearance requirements
and in your local building codes.
To determine the length of vent pipe required
for vertical installations, measure the distance
above the roof line.
needed, additional pipe, elbows and supports
will be required.
You will require the following Dura-Vent venting
components with your new CLASSIC Direct
Vent Freestanding Gas Stove. Please review
you need. In the event that you are missing any
part, contact your dealer.
for your particular installation. See
List" section.
If installing termination on a siding covered wall,
used in order to ensure that the termination is
not recessed into siding.
with vinyl siding.
Basic
1 90 o
1 Wall Thimble Cover
-
-
-
The FPI AstroCap
tems as well as Simpson Dura-Vent
Security Secure Vent ®
of Simpson Dura-Vent Co. Inc.
Alternate Horizontal
Termination Caps
®
Regency CLASSIC™ C34-10 Direct Vent Freestanding Gas Stove
®
installation
Alternate Snorkel
|
23
-
| 23