Venting Introduction; Installation Precautions; Safety Precautions For The Installer; Vent Restrictor Position - Regency C34 Classic Owners & Installation Manual

installation
|
14

VENTING INTRODUCTION

son Dura-Vent Direct Vent venting systems,
in combination with the Classic Direct Vent
Freestanding Gas Stove, C34-NG and C34-LP,
have been tested and listed as direct vent heater
of combustion to the outside while the outer pipe
draws outside combustion air into the combus-
tion chamber thereby eliminating the need to
use heated room air for combustion and losing
warm room air up the chimney.
nected to any other appliance.
The gas appliance and vent system must be
vented directly to the outside of the building,
and never be attached to a chimney serving a
separate solid fuel or gas burning appliance.
separate vent system. Common vent systems
are prohibited.
IMPORTANT
Read all instructions carefully before starting
the installation. Failure to follow these instruc-
venting and clearance to combustible require-
ments. Consult your local building codes before
beginning installation.
The location of the termination cap must conform
14 |
Regency CLASSIC™ C34-10 Direct Vent Freestanding Gas Stove
®
INSTALLATION
PRECAUTIONS
-
These venting systems are engineered products
that have been designed and tested for use with
the C34-NG10 and the C34-LP10. The warranty will
1. Installation of any damaged Direct Vent com-
ponent
2.
System
3. Installation of any component part not manu-
factured or approved by Simpson Dura-Vent or
Fireplace Products International Ltd.
4. Installation other than as instructed by Simpson
Dura-Vent and Fireplace Products International
Ltd.
-
spaces with insulation.
section and in your local building codes.
separate solid fuel or gas-burning appliance.
separate vent system. Common vent systems are
prohibited.
SAFETY
PRECAUTIONS
FOR THE INSTALLER
1. Wear gloves and safety glasses for protection.
2.
or on roof tops.
3.
and ceilings.
VENT RESTRICTOR
POSITION
Vent restriction is required for certain venting
required for your installation.
Simply loosen the screws and push the vent
restrictor plate to the correct position. Tighten
the screws.
-