Direct Vent System - Regency C34 Classic Owners & Installation Manual

Support extensions - Round (RDSE)
or square (SQSE)
Steep pitched cathedral ceilings may require the
inside the support and can be adjusted to increase
is attached to the support using the eight metal
CONVERTING
CLASS-A METAL
CHIMNEY TO

DIRECT VENT SYSTEM

General
of this type is shown in diagram 1. The concept
of direct vent conversion is to connect an adap-
then passed down through the center of the
of Top Adaptors are available from Simpson
Dura-Vent. The Retro Connector is attached
and the Retro Connector are attached to the
appliance is then connected to the chimney
adjustable length section.
condition exists. Do not operate the appliance
Converting a Factory Built Metal
Chimney
chimney to the bottom of the ceiling support
the underside of the Top Adaptor using 3
of the chimney system, and center the
adaptor on the top of the chimney pipe.
adaptor and into the chimney top. Insure
that you are in fact, drilling into the metal
Retro Connector by slipping it into the
to assemble these two parts.
-
Diagram 1
Regency
installation
sleeve for double wall
with the sheet metal
The holes in the Retro
Connector are pre-
the Retro Connector may be completed with
with an adjustable length.
CLASSIC™ C34-10 Direct Vent Freestanding Gas Stove
®
|
Diagram 2
Diagram 3
Diagram 4
Diagram 5
| 27
27