Vertical Termination - Regency C34 Classic Owners & Installation Manual

4.
run a bead of non-hardening mastic around
four wood screws provided. Seal around
should be pointing up. Insure that the
Diagram 5
recessed into the siding. The four
replaced with appropriate fasteners
for stucco, brick, concrete, or other
types of sidings.
5.
decorative wall thimble cover over the vent
pipe, then slide the Wall Thimble over the
vent pipe.
6. Slide the appliance and vent assembly
towards the wall carefully inserting the
vent pipe into the vent cap assembly. It is
inches. Secure the connection between the
vent pipe and the vent cap by attaching the
vent cap assembly into the outer wall of the
provided to connect the strips to the pipe
so it will be concealed by the decorative wall
thimble cover. See diagram 6.
Diagram 6
7.
8. Slide the decorative wall thimble up to the
wall surface being careful not to scratch the
paint and attach with screws provided. Apply
decorative brass or chrome trim if desired.
Diagram 7
VERTICAL
TERMINATION
1.
to combustibles when pass-
ing through ceilings, walls,
roofs, enclosures, attic rafter,
or other nearby combustible
surfaces.
the venting system and the
limitations.
2. Set the gas appliance in
its desired location. Drop a
plumb bob down from the
ceiling to the position of the
the location where the vent
will penetrate the ceiling. Drill
drop a plumb bob from the roof
to the hole previously drilled in
will penetrate the roof. Determine if ceiling
Regency
joists, roof rafters
other framing
will obstruct the
venting system.
You may wish
to relocate the
appliance or to
d i a g r a m
avoid cutting
load bearing
members.
3. To install the
ceiling, cut a 10 inch square hole in the
ceiling centered on the hole drilled in Step
4.
and elbows necessary to reach from the
appliance adaptor up though the Round
position and sealed.
5. Cut a hole in the roof centered on the small
the minimum requirements for clearance
6. Continue to assemble pipe lengths.
Diagram 8
bows, and possible separation. Wall
CLASSIC™ C34-10 Direct Vent Freestanding Gas Stove
®
installation
o r
i n
9 t o
Diagram 9
Diagram 10
-
|
25
-
25
|