Table of Contents
Advertisement
CYLINDER HEAD COVER DISTORTION
After removing sealant from the fitting surface of the cylinder
head cover, place the cylinder head cover on a surface plate
and check for distortion with a thickness gauge.
Service Limit:
0.05
mm
(0.002
in)
If the distortion exceeds the limit, replace the cylinder head
cover.
ROCKER ARM SHAFT
O.D.
Measure the diameter of rocker arm shaft with a micrometer.
Standard:
11.973-11.984
mm
(O.4714-0.4718
in)
_
09900-20205:
Micrometer
(O-25
mm)
ROCKER ARM I.D.
When checking the rocker arm, the inside diameter of the
rocker arm and wear of the camshaft contacting surface
should be checked.
Standard:
12.000-12.018
mm
(0.4724-0.4731
in)
_
09900-20605:
Dial calipers
ROCKER ARM AND SHAFT REASSEMBLY
• Apply SUZUKI MOLY PASTE to the rocker arm shafts.
~99000-25140:
SUZUKI MOLY PASTE
• Install the rocker arms and shafts as shown in the illus-
tration.
• Tighten the rocker arm shaft set bolts
CD
to the specified
torque.
[!J
Set bolt
CD:
28
N·m
(2.8
kg-m,
20.0
Ib-ft)
NOTE:
Use new gasket on the set bolts
CD.
ENGINE 3·18
Advertisement
Table of Contents
