SPEEDOMETER AND PILOT INDICATOR
REMOVAL AND DISASSEMBLY
• Remove the speedometer and pilot indicator. (Refer to page 5-4.)
• Disassemble the speedometer and pilot indicator as follows.
INSPECTION
Using the pocket tester, check the continuity between lead
wires in the diagram on next page.
If the continuity measured is incorrect, replace the respec-
tive parts.
,mob
09900-25002: Pocket tester
~Tester
knob indication: X 1Q range
NOTE:
When making this test, it is not necessary to remove the
speedometer and pilot indicator.
ELECTRICAL SYSTEM 6-22