Table of Contents
Advertisement
5-55 CHASSIS
• Loosen the spring pre-load adjuster lock ring and adjuster
ring fully with the special tool.
,roOl.
09910-60611: Universal clamp wrench
• Remove the spring seat
CD
and plate
@
by moving the
cushion
@
to the shock absorber cylinder side.
NOTE:
The removed plate
@
will not be used when reassembling
the shock absorber.
REASSEMBLY AND REMOUNTING
Reassemble and remount the rear shock absorber and air
cleaner in the reverse order of removal and disassembly. Pay
attention to the following points:
• When installing the spring seat
CD
to the shock absorber,
invert it from standard position.
• Position the cushion
@
against washer
@.
• Tighten the spring adjuster ring and adjust the spring pre-
load with the special tool. The standard set length is
247.5
mm.
• After adjusting the pre-load, tighten the adjuster lock ring
securely.
,-mb
09910-60611: Universal clamp wrench
SPRING SETTING TABLE
-------
Spring pre-set length
Softest
253.5
mm (10.0 in)
Standard
247.5 mm (9.7 in)
Stiffest
238.5
mm (9.4 in)
Advertisement
Table of Contents
