Panasonic WV-S2500 Series Operating Instructions Manual page 99

Click the [Reset] button to reset to the default setting.
•
Default: 16
[HLC level]
Adjust the high light compensation level.
If you move the slider in the "+" direction, the effect of high light compensation (HLC) will increase.
If you move the slider in the "-" direction, the effect of high light compensation (HLC) will decrease.
Click the [Reset] button to reset to the default setting.
•
Default: 16
[Mask area]
When mask area is set, the selected area is masked and you can adjust brightness. When "On" is selected
for "Super Dynamic(SD)", this setting is not available.
Refer to page 106 for information on how to set the mask area.
Light control mode
[Light control mode]
Select the light control mode from the following.
•
Outdoor scene: Depending on the brightness level (illuminance), the iris will automatically be controlled
together with the shutter speed adjustment to control light. When shooting a bright subject such as outdoor,
etc., select this parameter. Be aware that flicker may occur when a subject is under fluorescent lighting.
•
Indoor scene (50 Hz) / Indoor scene (60 Hz): The shutter speed will automatically be adjusted to prevent
flicker caused by fluorescent light. Select 50 Hz or 60 Hz corresponding to the location where the camera
is in use.
•
ELC
S11x2
•
Fix shutter:
–
When "2 mega pixel [16:9](60fps mode)" or "1.3 mega pixel [16:9](60fps mode)" is selected for "Image
capture mode":
1/60 Fix, 1/100 Fix, 1/120 Fix, 1/250 Fix, 1/500 Fix, 1/1000 Fix, 1/2000 Fix, 1/4000 Fix, 1/10000 Fix
–
When "2 mega pixel [16:9](30fps mode)", "1.3 mega pixel [16:9](30fps mode)", "3 mega pixel [4:3](30fps
mode)", or "1.3 mega pixel [4:3](30fps mode)" is selected for "Image capture mode":
1/30 Fix, 3/120 Fix, 2/100 Fix, 2/120 Fix, 1/100 Fix, 1/120 Fix, 1/250 Fix, 1/500 Fix, 1/1000 Fix, 1/2000
Fix, 1/4000 Fix, 1/10000 Fix
•
Default: Outdoor scene
Note
•
When a faster shutter speed is selected (up to 1/10000), it is possible to capture a fast moving object
with less blur.
•
When a faster shutter speed is selected, the sensitivity will become lower.
•
When "On" is selected for "Super Dynamic(SD)", "Fix shutter" and "ELC" are not available. To configure
"Fix shutter" and "ELC", set "Super Dynamic(SD)" to "Off".
: Uses shutter speed adjustment to control light.
S11x1
2 Settings
Operating Instructions 99