2 Settings
[E-mail notification]
Select "On" or "Off" to determine whether or not to provide notification by E-mail according to the settings for
the "Alarm" and "Diag." checkboxes of "Destination of notification" below.
–
When an alarm is detected ("Alarm")
–
When a notification of the remaining capacity of the SD memory card has been provided ("Diag.")
–
When the SD memory card has become full ("Diag.")
–
When the SD memory card cannot be recognized ("Diag.")
•
Default: Off
[Alarm image attachment]
Select "On" or "Off" to determine whether or not to attach an image to the E-mail to be sent when an alarm is
detected.
•
Default: Off
[Image capture size]
Select the image capture size of images attached to an alarm E-mail from the following.
JPEG(1)/JPEG(2)/JPEG(3)
•
Default: JPEG(2)
[SMTP server address]
Enter the IP address or the host name of the SMTP server used to send E-mails.
•
Available number of characters: 1 - 128 characters
•
Available characters: Alphanumeric characters, the colon (:), the period (.), the underscore (_), and the
hyphen (-).
[SMTP port]
Enter the port number to which E-mails are sent.
•
Available port number: 1-65535
•
Default: 25
The following port numbers are unavailable since they are already in use.
20, 21, 23, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[POP server address]
When "POP before SMTP" is selected for "Type", enter the IP address or the host name of the POP server.
•
Available number of characters: 1 - 128 characters
•
Available characters: Alphanumeric characters, the colon (:), the period (.), the underscore (_), and the
hyphen (-).
IMPORTANT
•
When entering the host name for "SMTP server address" or "POP server address", it is necessary to
configure the DNS settings on the [Network] tab of the "Network" page. (®page 152)
[Authentication]
•
Type
Select the authentication method to send E-mails from the following.
–
None: It is not necessary to clear any authentication to send E-mails.
–
POP before SMTP: It is necessary to first clear the POP server authentication to use the SMTP server
to send E-mails.
–
SMTP: It is necessary to clear the SMTP server authentication to send E-mails.
–
Default: None
158
Operating Instructions