Panasonic WV-S2500 Series Operating Instructions Manual page 13

The image in the main area is displayed based on the contents set in Stream(1) – (4) (®page 89),
JPEG(1) – (3) (®page 87), or Multi-screen (®page 124).
Also the first stream displayed when you accessed the camera can be set from "Initial display stream" of
the [Image] tab. For "Multi-screen", you can set the "Initial display" in the [Multi-screen] tab.
Note
•
When "2048´1536", "1920´1080", "1280´960" or "1280´720" is selected for the image capture
size, it may become smaller than the actual size depending on the window size of the web browser.
Stream information display
Displays the setup for stream encoding format, image capture size, bit rate, and frame rate for the live view
of a stream.
Note
•
Displays the values set in the stream. The actual bit rate and frame rate vary depending on the
network environment and the used PC.
[Refresh interval] pull-down menu
This pull-down menu will be displayed only when a JPEG image is displayed. Use it to select the display
method of the JPEG image.
•
MJPEG: Uses viewer software to display JPEG images successively as MJPEG (Motion JPEG). Not
available if the viewer software is not installed.
•
Refresh interval : 1s/Refresh interval : 3s/Refresh interval : 5s/Refresh interval : 10s/Refresh
interval : 30s/Refresh interval : 60s: Refreshes JPEG format (still images) images at the specified
interval.
Note
•
Depending on the network environment or the PC used, JPEG format (still images) images may
not be refreshed at the specified interval.
[Zoom] buttons
Images will be zoomed in on with the electronic zoom by the viewer software "Network Camera View
4S".
•
[x1] button: The images in the main area will be displayed at x1.
•
[x2] button: The images in the main area will be displayed at x2.
•
[x4] button: The images in the main area will be displayed at x4.
[Brightness] buttons
*2
The brightness is adjustable from 0 to 255. Click the
button to make the image darker. If you click the [Normal] button, the display will be reset to default.
[AUX] button
S11x2
These buttons will be displayed only when "Terminal 3" of "Alarm" is set to "AUX output" on the setup menu.
(®page 49)
•
[Open] button: The status of the AUX connector will be open.
•
[Close] button: The status of the AUX connector will be closed.
Note
•
The names of "AUX", "Open" and "Close" can be changed. (®page 129)
[Rec. on SD] button
*2
The [Rec. on SD] button will be displayed only when "Manual" is selected for "Save trigger" on the [SD
memory card] tab. (®page 72)
Click this button to manually record images on the SD memory card. Refer to page 25 for descriptions
of how to manually record images on the SD memory card.
S11x1 S15x1 S25x1
S11x2 S11x1 S15x1
button to make the image brighter, or click the
S22x1 S21x1
S25x1 S22x1 S21x1
1 Operations
Operating Instructions 13