Panasonic WV-S2500 Series Operating Instructions Manual page 93

•
Default: Off
Note
•
This feature can only be used for "Stream(1)".
[Refresh interval]
Select an interval (I-frame interval; 0.2 - 5 seconds) to refresh the displayed H.265 (or H.264) images from the
following.
If using under a network environment with frequent error occurrences, shorten the refresh interval for H.265
(or H.264) to diminish image distortions. However, the refresh interval may be longer than the set value.
0.2s/ 0.25s/ 0.33s/ 0.5s/ 1s/ 2s/ 3s/ 4s/ 5s
•
Default: 1s
Note
•
When "On(Low)" is selected for "GOP control", the refresh interval is set to Max. 8s.
•
When "On(Mid)" is selected for "GOP control", the refresh interval is set to Max. 16s.
•
When "On(Advanced)" is selected for "GOP control", the refresh interval is set to 60s.
[Transmission type]
Select the transmission type of H.265 (or H.264) images from the following.
•
Unicast port (AUTO): Up to 14 users can access a single camera concurrently. "Unicast port1(Image)"
and "Unicast port2(Audio)" will automatically be selected when transmitting images and audio from the
camera. When it is unnecessary to fix the port number for stream transmission such as when using in a
particular LAN environment, it is recommended to select "Unicast port (AUTO)".
•
Unicast port (MANUAL): Up to 14 users can access a single camera concurrently. It is necessary to select
"Unicast port1(Image)" and "Unicast port2(Audio)" manually to transmit images and audio from the camera.
It is possible to fix the port number of the router used for stream transmission via the Internet by setting
"Unicast port (MANUAL)" (®page 152). Refer to the operating instructions of the router in use.
•
Multicast: Unlimited number of users can access a single camera concurrently. Complete the entry field
of "Multicast address", "Multicast port" and "Multicast TTL/HOPLimit" when transmitting stream with
multicast. Refer to page 9 for further information about the maximum concurrent access number.
•
Default: Unicast port (AUTO)
[Unicast port1(Image)]
Enter the unicast port number (used to transmit images from the camera).
•
Available port number: 1024 - 50000 (Only even numbers are available.)
•
Default:
–
Stream(1): 32004
–
Stream(2): 32014
–
Stream(3): 32024
–
Stream(4): 32034
[Unicast port2(Audio)]
Enter the unicast port number (used to transmit audio from the camera).
•
Available port number: 1024 - 50000 (Only even numbers are available.)
•
Default:
–
Stream(1): 33004
–
Stream(2): 33014
–
Stream(3): 33024
–
Stream(4): 33034
[Multicast address]
Enter the multicast IP address. Images and audio will be transmitted to the designated IP address.
*1
*1
*2
2 Settings
Operating Instructions 93