Push Handles / Push Bars; Adjusting The Height Of The Connected Push Handles; Adjusting The Height Of The Push Bar - Invacare Rea Dahlia 30 User Manual

1. Make sure that the seat is not tilted before adjusting the
resistance.
Adjust the screw A to attain the desired resistance.
2.
Adjust the screw A outwards to decrease the resistance when
3.
tilting backwards. The resistance when raising the tilt will now
increase.
4. Adjust the screw A inwards to increase the resistance when
tilting backwards. The resistance when raising the tilt will now
decrease.
Tool: 5 mm allen key
The wheelchair always has the seat in standard position (0
degrees tilted) when it is delivered from the factory.

4.3 Push handles / Push bars

The following instructions and warnings are valid for all push handles
and the push bar.
Concerning the push handles/push bar for the bent backrest
tubes follow the instructions for height adjustment of the
push bar.
4.3.1 Adjusting the height of the connected push
handles
Loosen the hand wheels B.
1.
The height of the push handles braced / push bar A can be
2.
adjusted simply by pulling the handles upwards or pushing them
downwards.
3. Adjust to the height that you require.
4. Re-tighten the hand wheels.
A
Make sure that the hand wheel for the push handle A fits
the hole in the tubes. If the threaded tap of the hand wheel
B is more than app. 2,5 mm visible, the position is wrong.
Lower or raise the push handle to get the hand wheel in
the correct position.
1572307-F
A
B
B
The push bar/push handles braced A must not be pulled up
so that it protrudes more than 19 cm over the top edge of
the attachment.
CAUTION!
Risk of trapping fingers
– Do not trap your fingers between the push handles
braced and the neckrest attachment. (If you have a
tension adjustable backrest).

4.3.2 Adjusting the height of the push bar

A
Loosen the hand wheels A.
1.
2. Adjust the handles to the required height position. There are
two fixed positions available.
3. Re-tighten the hand wheels.
WARNING!
Risk of injury
The push bar can loosen from the attachments
– Make sure that the marking B on the tubes are fitted
against the backrest tube.
– Check that the handwheels can be tightened properly,
the screw of the handwheel should barely be visible. If
the push bar is in the wrong position, the handwheel
will not be possible to tighten properly.
Components
A
B
17