Adjusting The Armrest/Side Rest Depth; Mounting The Rear Wheels; Inserting The Legrests; Angle Adjustable Legrests - Invacare Rea Dahlia 30 User Manual

CAUTION!
Risk of trapping fingers
– Be careful not to trap your fingers between the
armrest / side support pad and the armrest attachment
when adjusting the armrest height.
•
Using low armrests, or adjusting the armrests in low
heights, may cause conflicts with the rear wheels when
tilting the chair.
•
The longer armrest (330 mm), is only available with the
"Ducktail" armrest pad.
The armrests have an auto-lock to prevent involuntary
movement or detachment. Press the button B on the
armrest to release before removing or adjusting the armrest.

3.7 Adjusting the armrest/side rest depth

A
1. Loosen the screw or the handwheel A, depending on which type
of armrest you have chosen
2. Set the pad and or the side rest in the required position.
3. Re-tighten the screw / handwheel.
Risk of poor adjustment
– There must not be any pressure on the armrest while
adjusting the screw.

3.8 Mounting the rear wheels

1572307-F
C
A
Press and hold in the quick-release button A.
1.
Place the rear wheel axle B in the rear wheel attachment C.
2.
3. Pull the wheels outwards to check that the wheel is securely
locked in position.
WARNING!
Risk of injury
– Check that the rear wheel is securely locked in
position! It should not be possible to remove the
wheels when the quick-release button A is inactivated.

3.9 Inserting the legrests

3.9.1 Angle adjustable legrests

1.
Turn the legrest outwards and push it down into the tubes of
the legrest attachment.
2.
Turn the legrest inwards to lock it into position.
The legrests are automatically locked, there is no risk of
them coming off the wheelchair.
Setup
11