Invacare Rea Dahlia 30 User Manual page 16

Rea® Dahlia® 30 / 45
Backrest angle adjustment
A
Adjust the angle of the backrest by using the yellow buttons on the
left side of the hand control A.
Press button B to adjust the angle of the backrest backwards.
1.
2. Press button C to adjust the angle forwards.
Tilt adjustment seat
A
Tilt the seat unit (seat and backrest) by using the green buttons on
the left side of the hand control A.
Press button B to adjust the angle of the seat unit backwards.
1.
Press button C to adjust the angle of the seat unit forwards.
2.
CAUTION!
Risk of trapping fingers
Could result in minor injuries.
– The risk of trapping fingers, etc., is greater in electric
adjustments than in user-operated adjustments.
– Bear in mind, for example, that a child may get hold of
the control box, press the controls and get trapped,
or trap the user.
– The hand control should only be used by authorised
personnel.
Charging the battery
Damage to the battery
– The battery must be loaded 24 hours before using the
system the first time.
– Unplug the mains cable after loading before using the
wheelchair.
The battery charger has different charging cables in order to
adapt to different local electrical standards.
16
B
C
When the battery level is low (20 %), the system beeps when
it is in use.
Connect charger cable
CAUTION!
Damage to the cables.
– Do not sit in the wheelchair while charging the battery.
A
A
A
1. Connect the charger cable supplied with the chair into a wall
socket.
Insert the charger cable A into the connector B which is located
2.
on the front of the wheelchair.
3. Unplug the cable when the battery is fully charged.
Hand control — Battery indications
C
D
A Green light — ON — Hand control is activated
•
B
Green light — ON — Battery level is above 20%
•
Green light blinking — ON — Battery is charging (fixed
light when the battery is fully loaded)
•
C Yellow light — ON — Battery level is low, below 20%
D Green light — ON — Battery cable is connected (lights up
about 5 seconds after connecting the cable)
Adjusting the resistance of the tilt function
The resistance of the tilt function can be adjusted in order to increase
or decrease the resistance when tilting. The resistance can be
adjusted individually for every user:
B
B
A
A
1572307-F