Push Handles / Push Bars; Adjusting The Height Of The Connected Push; Handles - Invacare Rea Dahlia 30 User Manual

Rea® Dahlia® 30 / 45
Hand control — Battery indications
C
D
Green light — ON — Hand control is activated
A
• Green light — ON — Battery level is above 20%
B
• Green light blinking — ON — Battery is charging
(fixed light when the battery is fully loaded)
• Yellow light — ON — Battery level is low, below
C
20%
Green light — ON — Battery cable is connected
D
(lights up about 5 seconds after connecting the
cable)
Adjusting the resistance of the tilt function
The resistance of the tilt function can be adjusted in order
to increase or decrease the resistance when tilting. The
resistance can be adjusted individually for every user:
1. Make sure that the seat is not tilted before adjusting
the resistance.
2. Adjust the screw A to attain the desired resistance.
3. Adjust the screw A outwards to decrease the resistance
when tilting backwards. The resistance when raising the
tilt will now increase.
4. Adjust the screw A inwards to increase the resistance
when tilting backwards. The resistance when raising the
tilt will now decrease.
Tool: 5 mm allen key
The wheelchair always has the seat in standard
position (0 degrees tilted) when it is delivered from
the factory.

3.6 Push handles / Push bars

The following instructions and warnings are valid for all push
handles and the push bar.
14
B
A
A
Concerning the push handles/push bar for the bent
backrest tubes follow the instructions for height
adjustment of the push bar.
3.6.1 Adjusting the height of the connected
push handles
1. Loosen the hand wheels B.
2. The height of the push handles braced / push bar A can
be adjusted simply by pulling the handles upwards or
pushing them downwards.
3. Adjust to the height that you require.
4. Re-tighten the hand wheels.
A
Make sure that the hand wheel for the push handle
A fits the hole in the tubes. If the threaded tap of
the hand wheel B is more than app. 2,5 mm visible,
the position is wrong. Lower or raise the push handle
to get the hand wheel in the correct position.
The push bar/push handles braced A must not be
pulled up so that it protrudes more than 19 cm over
the top edge of the attachment.
CAUTION!
Risk of trapping fingers
– Do not trap your fingers between the push
handles braced and the neckrest attachment.
(If you have a tension adjustable backrest).
A
B
B
A
1572307-J