Toshiba e-STUDIO206L Service Manual page 1437

Sub
05/08 Mode Element
element
08 Setting Image Image SCN
mode Processin
g
08 Setting Image User User mode setting
mode Processin interface
g
08 Setting System General
mode
08 Setting System General
mode
08 Setting System General Wide A4 Mode (for
mode PCL)
08 Setting System General
mode
08 Setting System General
mode
08 Setting System General Outside erase
mode judgment threshold
(Default)
08 Setting System General Outside erase
mode judgment threshold
(Default)
e-STUDIO207L/257/307/357/457/507
Item Subitem Code
8300
SCN 8303
8504
8506
8511
8512
8514
PPC 8515
SCN 8516
Sub- Default Acceptable
Details
code value value
ADF scan noise 3
reduction
Color 0 0~4
Feeding method of 0 0~1
odd page number in
duplex printing(Raw
print)
Forcible mode 1 0~2
change in cartridge
empty status
PRT 0 0~1
Number of jobs in 10 2~10
batch processing
Threshold value 20 5~30
setting for RIP
standard paper
judgment
PPC 0 -3~3
SCN 0 -3~3
94
RAM Contents
0-3 SYS Sets the adjustment level for reducing color streaks
when the RADF is used.
3: Disabled (default)
2: Noise reduction level - Low
1: Noise reduction level - Middle (recommended)
0: Noise reduction level - High
SYS 0: Unused 1: Text/Photo base 2: Text base 3: Photo
base 4: e-document base
* e-document: This is the mode that corresponds to the
law in Japan. This mode is used to clarify area where
changes were made with such as a correction fluid.
SYS 0: One side 1: Both sides
SYS 0: SLEEP MODE 1: AUTO POWER SAVE 2: READY
SYS 0: Disable 1: Enable
SYS 2-10: From 2 to jobs can be specified
SYS This code is used for changing the range in which the
non-standard paper size is judged as standard paper
size. If the page size information is within standard
paper size ± setting value, the page size is judged as
standard paper size when PS/PDF printing. If the page
size information is out of the range, the page size is
judged as non-standard paper size. The unit of setting
value is PS point. 1 PS point is approx. 0.35 mm.
SYS The larger the value is, area to be erased increases.
The smaller the value is, area to be erased decreases.
SYS The larger the value is, area to be erased increases.
The smaller the value is, area to be erased decreases.
Proc Service
edure UI
1
1 Yes
1
1
1
1
1 Yes
1
1