Toshiba e-STUDIO206L Service Manual page 1446

Sub
05/08 Mode Element
element
08 Setting System User
mode interface
08 Setting System User
mode interface
08 Setting System Network
mode
08 Setting System User
mode interface
08 Setting System FAX
mode
08 Setting System User
mode interface
e-STUDIO207L/257/307/357/457/507
Item Subitem Code
8717
8718
8719
8720
8721
8722
Sub- Default Acceptable
Details
code value value
Shutdown operation 0
when Super Sleep is
enabled
Selection for caching 0 0-17
the screen of control
panel at start-up
MTU setting of 1500 576-1500
network
communication
Department code 0
display with asterisk
Automatic FAX 0
sending at AutoClear
when scanning
original put on the
glass
Display method of 0
"Cannot find the
Home Directory" on
the control panel
103
RAM Contents
0-1 SYS Sets the operation when the power button on the
control panel is press for a few seconds if Super Sleep
is enabled.
0: Hibernation
1: Super Sleep
SYS Use this code to shorten the time to switch the function
on the control panel for the first time immediately after
start-up. However, the start-up time becomes longer
(about 1 to 3 seconds per screen). When selecting
multiple screens, enter the total value.
0: Disabled
1: Copy
16: Fax
NIC Normally there's no need to change the MTU value. Set
the proper MTU value when MFP is connected to the
Internet using broadband router and so on.
0-1 SYS 0: Displays department code with asterisk when
inputting it.
1: Displays department code as it is when inputting it.
0-1 SYS Sets whether the job is sent or canceled when
AutoClear is executed on the interruption screen to
confirm the next original displayed after scanning the
original put on the glass. Use this code to cancel job
when the equipment is left unattended while the
interruption screen is displayed.
0: Sends job
1: Cancels job
0-1 SYS Sets the display method of error if the Home Directory
for user cannot be obtained from the server when
setting the Home Directory for scanning. Use this code
to disable the pop-up display when the Home Directory
cannot be obtained depending on the user.
0: Displays the pop-up dialogue when user logs in
1: Displays the message in the guidance area when the
Scan to File screen is displayed
Proc Service
edure UI
1 Yes
1
12
1 Yes
1 Yes
1 Yes