Toshiba e-STUDIO206L Service Manual page 1447

Sub
05/08 Mode Element
element
08 Setting System User
mode interface
08 Setting System User
mode interface
08 Setting System User
mode interface
08 Setting System General
mode
08 Setting System User Card reading device
Mode interface
08 Setting System Forced
Mode printing of
user name
08 Setting System Forced
Mode printing of
user name
08 Setting System Forced
Mode printing of
user name
e-STUDIO207L/257/307/357/457/507
Item Subitem Code
8723
8724
8725
8726
8727
8728
8728
8728
Sub- Default Acceptable
Details
code value value
Pop-up display of 1
logging out of user
authentication and
department
management on the
control panel
Display setting of Edit 1
From Address button
for Scan to email
Display setting of 1
[USER FUNCTIONS]-
> CHANGE
LANGUAGE button
Job deletion on the 0
Job Status screen
Display of dedicated 0
screen for card
authentication
0 Display/Non-display 0
setting in TopAccess
1 Enable/Disable 0
setting of forced
printing
2 Prioritizing printer 1
driver setting
104
RAM Contents
0-1 SYS Sets whether the pop-up dialog of confirmation for
logging out is displayed when user or department logs
out by pressing [FUNCTION CLEAR] button twice or
pressing [ACCESS] button.
0: Logs out without displaying pop-up dialog
1: Displays pop-up dialog when logging out
0-1 SYS 0: Not displayed (From Address cannot be edited)
1: Displayed (From Address can be edited)
0-1 SYS Sets whether the [CHANGE LANGUAGE] button
accessed from [USER FUNCTIONS] button is
displayed or not. Use this code to prohibit users from
changing the language displayed on the control panel.
Administrators can change the language.
0: Not displayed
1: Displayed
0-1 SYS Use this code to enable the job deletion on the [Job
Status] screen. When "3: High level" is set for code 08-
8911, be sure to disable this setting.
0: Disabled
1: Enabled
0-1 SYS Switches whether the message to hold a card over the
card reader is displayed on the login screen when the
card authentication is enabled.
0: Disabled
1: Enabled
0-1 SYS 0: Disabled 1: Enabled
0-1 SYS Normally this setting is made in TopAccess.
0: Disabled 1: Enabled
0-1 SYS Normally this setting is made in TopAccess.
0: Disabled 1: Enabled
Proc Service
edure UI
1 Yes
1 Yes
1 Yes
1 Yes
1
4
4
4