Creating A Sector Search Pattern; Utilities - Garmin GTN 625 Pilot's Manual

5. Touch the TRK SPCNG key to open the keypad. Use the keypad
and Enter to select the desired spacing between the parallel
track legs.
6. Touch the Leg Count key to open the keypad. Use the keypad
and Enter to select the desired number of parallel track legs.
7. Touch the Preview key to open a preview of the selected
pattern.
8. Touch the Load Pattern key to load selected pattern to the
active flight plan.
Or
9. Touch the Load PTRN & Activate key to load selected pattern
to the active flight plan and go direct-to the initial waypoint.
4.2.4.2

Creating a Sector Search Pattern

The Sector Search SAR pattern starts at the initial waypoint and follows the
initial track for the desired leg length. A 60° turn in the initial turn direction is
followed by another leg with the desired leg length, another 60° turn, and then
a leg back to the initiating waypoint. The next sector starts with a leg continuing
on the same course outbound from the initiating waypoint and is followed by
the same sequence of legs and turns. The third sector follows the same pattern.
The default initial track for the Sector Search Pattern is True North.
Selected Initial Wpt
Touch To Select SAR
Pattern Type
Touch To Select
Initial Turn Direction
Touch To Preview
Selected Pattern
Figure 4-34 Search and Rescue Sector Search Pattern Page
190-01004-03 Rev. K
Touch To Select
Leg Length
Touch To Load Selected Pattern
To The Active Flight Plan
Garmin GTN 625/635/650 Pilot's Guide
Touch To Select
Initial Track
Touch To Load
Selected Pattern To
The Active FPL And
Go Direct-To The First
Wpt In The Pattern
4-17
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music

Utilities

System
Messages
Symbols
Appendix
Index