Table of Contents
Advertisement
CompactFlash Memory Card Product Manual
2.3
System Performance
All
performance
CompactFlash Memory Card Series controller is in
the default (i.e., fastest) mode.
Active to Sleep Delay
Note:
The Sleep to Write and Sleep to Read times are the times it takes the CompactFlash Memory Card to exit
sleep mode when any command is issued by the host to when the card is reading or writing. CompactFlash
Memory Cards do not require a reset to exit sleep mode. See section 1.8.6.
2.4
System Reliability and
Maintenance
MTBF (@ 25°C)
Preventive Maintenance
Data Reliability
Endurance SDCFB-XX
Endurance SDCFBI-XX Industrial Product
2.5
Physical Specifications
Refer to the following table and to Figure 2-1 for
CompactFlash
Memory
specifications and dimensions.
Model SDCFB-XX
16
timings
assume
Start Up Times
Reset to ready:
Data Transfer Rate
To/From Flash
Data Transfer Rate
To/From Host
Controller Overhead Command to DRQ 1.25 msec maximum
Card
physical
SanDisk CompactFlash Memory Card Product Manual © 1998 SANDISK CORPORATION
the
Sleep to write:
2.5 msec maximum
Sleep to read:
2.0 msec maximum
50 msec typical
400 msec maximum
Programmable
4.0 MBytes/sec burst
6.0 MBytes/sec burst
>1,000,000 hours
None
<1 non-recoverable error in 10 14 bits read
300,000 erase / program cycles per logical sector
guaranteed
100,000 erase / program cycles per logical sector
guaranteed
Weight: 11.4 g (.40 oz) typical
All Models 14.2 g (.5 oz) maximum
Length: 36.40 ± 0.15 mm (1.433 ±.006 in)
Width: 42.80 ± 0.10 mm (1.685 ±.004 in)
Thickness:
3.3 mm ± 0.10 mm (.130 ±.004 in)
Excluding Lip
Advertisement
Table of Contents
