Appendix Compactflash Connector Specifications - SanDisk CompactFlash Product Manual

Appendix CompactFlash Connector Specifications

This appendix includes specifications for CompactFlash connectors as defined by the CompactFlash
Association. See the Ordering Information section of this manual for a list of CompactFlash connector
vendors.
Table 1 Connector Interface Requirements
Category
Physical Housing Material
Housing Flammability Rating
Electrical Contact Resistance
Performance (w/ bulk)
Current Rating
Insulation Resistance
Dielectric Withstanding
Voltage
Mechanical Single Socket Holding Force
Performance Single Pin Holding Force
Total Mating Force
Total Unmating Force
Durability
Environmental Mechanical Shock
Performance Vibration
Humidity
Thermal Shock
Mixed Flowing Gas
CompactFlash Memory Card Product Manual © 1998 SANDISK CORPORATION
Appendix CompactFlash Connector Specifications
Item
High Temperature Plastic
UL 94V-0
40 milliohms maximum, initial
20 milliohms maximum change, throughout testing
0.5 Amperes per contact, without exceeding
o
30 C temperature rise above ambient
1000 Megaohms minimum, initial
100 Megaohms minimum, after 1 minute at 500 Vdc
No shorting during 1 minute at 500 Vac rms, with
1 mA maximum current leakage
4.9 N minimum push out at 25 mm/minute
9.8 N minimum push out at 25 mm/minute
28.8 N maximum at 25 mm/minute
4.9 N minimum and 28.8 N maximum at 25 mm/minute
10,000 mating cycles, without exceeding low-level contact EIA-364-09B
resistance
No discontinuities greater than 100 ns, Test Condition A
No discontinuities greater than 100 ns, Test Condition III
10 (24 hour) cycles with connector mated
o
-55 C to +85
Environmental Class II for 96 hours with connector
unmated
Figure 1 50 Position, Two Row Pin Pattern
Standard
o
C, 5 (1 hour) cycles
Test
Method
Certification
EIA-364-23A
IEC-512-PT3
EIA-364-21A
EIA-364-20A
EIA-364-29A
EIA-364-29A
EIA-364-13A
EIA-364-13A
EIA-364-27A
EIA-364-28A
EIA-364-31A
EIA-364-32B
EIA-364-65
111