Installation; General Information; Unpacking; Locate And Install The Pr70 - Graco PR70 Series Operation And Maintenance Manual

Installation

Installation

General Information

Accessories are available from Graco. Make certain all
accessories are adequately sized and pressure-rated to
meet your system needs.
Figures 2 thru 4 are only a guide for identifying system
components and for assisting in installation. Contact
your Graco distributor or Graco Ohio Customer Service
for assistance in designing a system to suit your
particular needs.

Unpacking

1. Inspect the shipping container carefully for damage.
Contact the carrier promptly if there is damage.
2. Open the box and inspect the contents carefully.
There should not be any loose or damaged parts in
the container.
3. Compare the packing slip against all the items in
the box. Report any shortage or other inspection
problems immediately.
4. Remove the PR70 system components from the
container. Do not lift the machine by the tanks.

Locate and Install the PR70

1. Locate a bench top or equivalent location to
mechanically mount the PR70 dispensing machine.
Figure 1: Mounting Hole Dimensions for Installing the PR70 Machine (dimensions in inches/mm)
312393C
Verify the location has access to compressed air,
AC power and is well ventilated.
2. Place the PR70 onto the designated location. Allow
to the machine to rest on the rubber feet provided.
3. Turn the Shield Locking Screws clockwise on both
sides to remove the PR70 protective shield.
4. Attach the PR70 frame to the selected location by
installing fasteners (not provided with unit) thru the
4 mounting holes. Refer to Figure 1 for mounting
hole dimensions.

Machine Setup

Avoid contact with electrical inter-connects, when connecting electric
power to the machine. Read all manufacturer's warning and material
MSDS to know the specific hazards of the material used.
1. Connect a compressed airline to the input air in the
back of the machine.
2. Load material into the on-board or off-board tanks
feeding the machine.
3. Using the power cord provided, connect AC power
(100-240V, 50/60 Hz, single-phase) to the machine.
10 of 52