Hmi Main Run Screen; Run Screen Operation; Machine Mode Selection; Machine Operation: Shot Mode - Graco PR70 Series Operation And Maintenance Manual

2 component liquid dispensing system
Hide thumbs Also See for PR70 Series:
Table of Contents

Advertisement

Run Screens

HMI Main Run Screen

Figure 6: Typical PR70 Main Run Screen (Shot and Operator Modes) Respectively)
Key:
A
Shot Number Field ("x" in Operator Mode)
B
Shot Size Field ("XXXXXX" in Operator Mode)
C
Shot weight/mass unit of measure (Grams).
D
Tank Fill Status Indicators
E
Pistons Status Field

Run Screen Operation

Read all manufacturer's warning and material MSDS to know the
specific hazards of the material used.

Machine Mode Selection

To dispense material, one of the following 2 modes
must be selected;
Shot mode dispenses a predetermined amount
of material when the machine receives a "Go"
command.
Operator mode dispenses material as long as
the machine is receiving a "Go" command.
To select Shot mode:
1. Press
until
2. Press
to accept or
To select Operator mode:
3. Press
until
4. Press
to accept or

Machine Operation: Shot Mode

1. Place the item or part to be filled below the
dispense valve static mixer
2. Press
(green) or the footswitch to start the shot.
312393C
.
to cancel.
.
to cancel.
F Cycle Counter
G DV status Field
H Purge Timer status Field
I
Error code status Field
J
Current Date Field (DD-MM-YY)
K Current Time Field (24 Hr. Format)
3. To cancel the shot, press

Machine Operation: Operator Mode

1. Place the item or part to be filled below the
dispense valve static mixer.
2. Press and hold
(green) or the footswitch to start
the shot. The machine will continue to dispense
until the
(green) or the footswitch is released.
The pistons will not retract unless they are almost fully
extended. They will automatically retract after 4
minutes. The machine will beep to signal that it is about
to retract. To manually retract the machine, press

Shot Number Selection

In Shot mode, up to 5 predefined shot sizes may be
selected. To select a shot:
1. When the machine is idle (not dispensing a shot)
press
or
to select the new shot size.
2. Press
to accept, or
.
.
to cancel.
13 of 52

Advertisement

Table of Contents
loading

Table of Contents