Table of Contents
Advertisement
Table 1 LED Descriptions (continued)
LED
USB
1.6 The RESET Button
If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the password will be reset to "1234".
Make sure the PWR/SYS LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for ten seconds or
2
until the PWR/SYS LED begins to blink and then release it. When the PWR/SYS LED begins to
blink, the defaults have been restored and the device restarts.
1.7 Wireless Access
The VMG is a wireless Access Point (AP) for wireless clients, such as notebook computers or PDAs
and iPads. It allows them to connect to the Internet without having to rely on inconvenient Ethernet
cables.
You can configure your wireless network in either the built-in Web Configurator, or using the WPS
button.
Figure 5 Wireless Access Example
1.7.1 Using the Wi-Fi and WPS Buttons
If the wireless network is turned off, press the Wi-Fi On/Off button for one second. Once the
WLAN/WPS LED turns green, the wireless network is active.
You can also use the WPS On/Off button to quickly set up a secure wireless connection between
the VMG and a WPS-compatible client by adding one device at a time.
Chapter 1 Introducing the VMG
COLOR
STATUS
DESCRIPTION
Green
On
The VMG recognizes a USB connection through the USB slot.
Blinking
The VMG is sending/receiving data to /from the USB device connected
to it.
Off
The VMG does not detect a USB connection through the USB slot.
VMG5313-BXB Series User's Guide
21
Advertisement
Table of Contents
