Table of Contents
Advertisement
interface with the VMG itself as the gateway for the LAN network. When you use IP alias, you can
also configure firewall rules to control access to the LAN's logical network (subnet).
If your ISP provides the Public LAN service, the VMG may use an LAN IP address that can be
accessed from the WAN.
Click Network Setting > Home Networking > Additional Subnet to display the screen shown
next.
Figure 55 Network Setting > Home Networking > Additional Subnet
The following table describes the labels in this screen.
Table 35 Network Setting > Home Networking > Additional Subnet
LABEL
DESCRIPTION
IP Alias Setup
Group Name
Select the interface group name for which you want to configure the IP alias settings. See
Chapter 15 on page 184
Active
Select Enable to configure a LAN network for the VMG.
IPv4 Address
Enter the IP address of your VMG in dotted decimal notation.
Subnet Mask
Your VMG will automatically calculate the subnet mask based on the IPv4 address that you
assign. Unless you are implementing subnetting, use this value computed by the VMG.
Public LAN
Active
Select Enable to enable the Public LAN feature. Your ISP must support Public LAN and
Static IP.
IPv4 Address
Enter the public IP address provided by your ISP.
Subnet Mask
Enter the public IPv4 subnet mask provided by your ISP.
Offer Public IP
Select Enable to enable the VMG to provide public IP addresses by DHCP server.
by DHCP
Enable ARP
Select Enable to enable the ARP (Address Resolution Protocol) proxy.
Proxy
Apply
Click Apply to save your changes.
Cancel
Click Cancel to exit this screen without saving.
Chapter 8 Home Networking
for how to create a new interface group.
VMG5313-BXB Series User's Guide
130
Advertisement
Table of Contents
