Add/Edit Port Forwarding - ZyXEL Communications VMG5313-BXB SERIES User Manual

11.2.1 Add/Edit Port Forwarding

Click Add New Rule in the Port Forwarding screen or click the Edit icon next to an existing rule
to open the following screen.
Figure 79 Port Forwarding: Add/Edit
The following table describes the labels in this screen.
Table 58 Port Forwarding: Add/Edit
LABEL
Active
Service Name
WAN Interface
WAN IP
Start Port
End Port
Translation
Start Port
Translation End
Port
Chapter 11 Network Address Translation (NAT)
DESCRIPTION
Clear the checkbox to disable the rule. Select the check box to enable it.
Enter a name to identify this rule using keyboard characters (A-Z, a-z, 1-2 and so on).
Select the WAN interface through which the service is forwarded.
You must have already configured a WAN connection with NAT enabled.
Enter the WAN IP address for which the incoming service is destined. If the packet's
destination IP address doesn't match the one specified here, the port forwarding rule will
not be applied.
Enter the original destination port for the packets.
To forward only one port, enter the port number again in the End Port field.
To forward a series of ports, enter the start port number here and the end port number in
the End Port field.
Enter the last port of the original destination port range.
To forward only one port, enter the port number in the Start Port field above and then
enter it again in this field.
To forward a series of ports, enter the last port number in a series that begins with the port
number in the Start Port field above.
This shows the port number to which you want the VMG to translate the incoming port. For
a range of ports, enter the first number of the range to which you want the incoming ports
translated.
This shows the last port of the translated port range.
VMG5313-BXB Series User's Guide
163