Manual Mode Operation - Honda HRM300/500 Owner's Manual

Manual mode operation

Manual mode operation
This setting can be used when 2 or more areas within the boundary wire are connected by a narrow path.
If you have 2 or more areas within the boundary wire connected by a path that is less than 1 meter wide,
the lawnmower cannot pass between them, and must be carried to the other area manually. Follow the
steps below when performing this procedure.
See "Manual Mode Setup settings" (M page 36) to configure settings for Manual Mode.
1
Press the B (Off) button on the control panel.
2
The power turns off.
Carry the lawnmower to the desired zone.
3
For details on carrying the lawnmower, see "7 MAINTENANCE" (M page 49).
Press the A (On) button on the control panel.
4
The power turns on, and the startup screen on the control panel is displayed.
Press the D (Auto / Manual) button repeatedly until
5
the [MAN] icon is displayed.
For details on the icons in the screen, see "Home
screen" (M page 11).
The lawnmower automatically begins to operate.
NOTE:
- The lawnmower does not turn off automatically when in manual mode.
To finish operation, press the manual STOP button from behind the lawnmower.
6
Press the B (Off) button on the control panel.
7
The power turns off.
Place the lawnmower in a zone that is near the docking station.
8
Press the A (On) button on the control panel.
9
The power turns on, and the startup screen on the control panel is displayed.
Press the C (Home) button.
10
The lawnmower returns to the docking station.
60
Standby
1 . M e n u
S u n
1 3 : 2 7
MAN
9 8 %