Configuring Zone Settings - Honda HRM300/500 Owner's Manual

Quick Setup

Configuring zone settings

In addition to the default Quick Setup mode Zone 1 (for which zone settings
cannot be changed), a configurable Zone 2 is available. The zone-specific
settings are as follows.
Until the lawnmower reaches a set point in a zone, it will
run without mowing.
L [1.Wire Exit Location] (M page 18)
- Sets the distance from the docking station to start cutting.
Set a zone operation ratio if you want to mow more frequently in a certain zone.
For example, if you set the ratio to 30%, the lawnmower will operate 3 times out of 10 in
Zone 2 and 7 times out of 10 in Zone 1.
L [2.Zone Proportion (%)] (M page 19)
Setting the boundary wire location at which the lawnmower
starts mowing
Home screen
[1.Wire Exit Location]
J
The lawnmower travels to this location along the
boundary wire, and then turns away from the
boundary wire to begin mowing.
This lets you focus mowing on a specific area of your
lawn.
18
Set whether the lawnmower should travel clockwise or
anticlockwise along the boundary wire to reach a zone.
L [1.CW] or [2.ACW] in [1.Wire Exit Location] (M page 18)
Zone 2
Narrow Path
[2.Quick Setup]
J
Zone 1
[2.Zone]
J
Enter a value from 0 to 250 for [0-250m].
1
Enter a number to select [1.CW] or
2
[2.ACW] for [1.CW/2.ACW].
Press the H button.
3
The message "Activated" is displayed.
Press the H button to return to the
4
previous screen.