Usage; Checking The Mowing Area; Connecting To A Power Source - Honda HRM300/500 Owner's Manual

Checking the mowing area / Connecting to a power source
5

USAGE

Checking the mowing area

Before operating the lawnmower, ensure the mowing area is free of
pets and foreign objects.
CAUTION:
- If there are any holes (such as rabbit holes, etc.) in the work
area, fill them in so that the work area is level. Periodically
check the work area for holes.
Also confirm that the height of the grass is 7 cm or less.
If the grass is taller than 7 cm, cut the grass using a standard lawnmower.

Connecting to a power source

Follow the steps below when connecting to a power source.
Follow these steps in reverse when disconnecting from a power source.
For details on moving the transformer or changing to a different power outlet, contact your dealer.
Remove the connector cover from the station.
1
Connect the power cord connector to the station's internal
2
connector.
NOTE:
- When disconnecting the connectors, make sure to lift the clip.
Attach the connector cover to the station.
3
(The power cord and boundary wire should go through the notch in the
connector cover.)
Connect the power cord and the transformer connectors.
4
NOTE:
- When disconnecting the connectors, make sure to lift the clip.
Connect the transformer plug to a power outlet with the designated voltage.
5
Power outlet voltage for the EAE and EAS types: AC 230 V
Power outlet voltage for the EAB type: AC 240 V
40
7 cm or less
Power cord
Transformer