Confirm the day selection
and display the screen
for setting the time.
Select the day.
Select the zone.
Configuring zone settings
You can set up to 5 zones in which the lawnmower operates. The zone-
specific settings are as follows.
When leaving the boundary wire,
set the angle to turn from the
boundary wire.
L [2.Exit Angle] (M page 24)
- Set the angle of departure for
when the lawnmower arrives at
the position specified by [1.Wire
Exit Location].
Set the distance that
the lawnmower can
cross the boundary
wire.
L [1.Wire Overlap] in
[4.Area] (M page 25)
Custom Setup
Ti m e r
0 . O K
9 . S e l e c t A l l
1 . M o n d a y
2 . Tu e s d a y
3 . We d n e s d a y
4 . T h u r s d a y
Custom Setup
Ti m e r
S t a r t
Ti m e r 1
11 : 0 0 - 11 : 4 5
1 . Z o n e 1 : Z o n e 1 - 5
Ti m e r 2
0 0 : 0 0 - 0 0 : 0 0
1 . Z o n e 1 : Z o n e 1 - 5
Until the lawnmower reaches a set point in a zone, it will
run without mowing.
L [1.Wire Exit Location] (M page 24)
- Sets the distance from the docking station to start cutting.
To pass through a narrow passage located between
zones, run the lawnmower just above the boundary wire.
L [2.Passage Width (Out)] in [4.Area] (M page 26)
- Specify the distance of the lawnmower from the
boundary wire.
S u n
1 3 : 2 7
Select all days.
This mark indicates that
there is another page.
Use the E / F buttons
to change pages.
S u n
1 3 : 2 7
: We d n e s d a y
E n d
Set the time.
Set whether the
lawnmower should travel
clockwise or anticlockwise
along the boundary wire to
reach a zone.
L [1.CW] or [2.ACW] in
[1.Wire Exit Location]
(M page 24)
Custom Setup
23