Fujitsu PRIMERGY RX300 S4 Options Manual page 78

Installing the external serial interface
V
CAUTION!
Keep the rear cover of the PCI slot for future use. If you remove the
controller again and do not replace it with a new one, the rear cover
must be reinstalled to comply with EMC regulations and to satisfy
cooling requirements and fire protection measures.
Figure 63: Installing external serial cable
Ê Insert the slot cover with the serial interface.
Ê Fasten the slot cover with a screw.
Ê Route the serial cable, as shown in the picture.
Ê Insert the air duct, see
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
78
"Inserting air duct" on page
81.
Options Guide
External serial interface
81.
RX300 S4