Table of Contents
Advertisement
SAS controller
Upgrading a SAS controller
X1
X2
Figure 53: Inserting controller
Ê Install the controller in the PCI slot 1 and press it carefully down.
Ê Fasten the slot cover with a screw.
Ê Connect plug X1 up and plug X2 down on the controller.
Ê Insert the air duct, see
"Inserting air duct" on page
81.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the
chapter "Completion" on page
81.
Options Guide
69
RX300 S4
Advertisement
Table of Contents
