Fujitsu PRIMERGY RX300 S4 Options Manual page 11

Introduction
ServerBooks DVD).
In addition, CSS errors are displayed in ServerView S2, the server
management software from Fujitsu Siemens Computers.
In the event of errors, ServerView S2 refers you directly to the affected
component and its order information in the Illustrated Spares catalog of the
server in question.
Hard disk drives
The server includes two drive cages for one of the following hard disk drive
configurations:
– 3.5-inch SAS/SATA hard disk drives: up to six (2x3) hard disk drive (HDD)
modules, each with a 3.5-inch SAS/SATA hard disk drive.
– 2.5-inch SAS hard disk drives: up to six (1x6) HDD modules, each with a 2.5-
inch SAS hard disk drive.
– 2.5-inch SAS hard disk drives: up to twelve (2x6) HDD modules, each with
a 2.5-inch SAS hard disk drive.
The module is connected to the SAS/SATA backplane without cables. This
allows hard disk drive modules to be simply plugged in or pulled out (for further
details see in chapter „Hot-plug components" in the operating manual).
The hard disk subsystem is designed for SAS/SATA, each with one channel for
each hard disk drive.
If the server has a RAID configuration, the HDD modules can be exchanged
during operation (hot-swap).
I
The three basic configurations are variants and can not be converted into
an other variant in the field.
Additional controllers
The system board offers seven PCI slots. Slots 1, 2, 3, 5, 6 and 7 are PCI-e x4
slots. Slot 4 is a PCI slot with a PCI bus speed of 133MHz. If slot 2 or 5 are not
occupied, slot 3 or 6 can be used octuple.
Additional Battery module
Optionally you can install an additional battery for use with a PCI controller.
RX300 S4
Options Guide
Options and upgrade
11