Fujitsu PRIMERGY RX300 S4 Options Manual page 66

Installing a PCI controller
V
CAUTION!
Keep the rear cover of the PCI slot for future use. If you remove the
controller again and do not replace it with a new one, the rear cover
must be reinstalled to comply with EMC regulations and to satisfy
cooling requirements and fire protection measures.
Figure 50: Inserting controller
Ê Install the controller in the PCI slot and press it carefully into the associated
plug-in location on the system board.
Ê Fasten the slot cover with the screw.
Ê If required, connect the cables to the controller and other components.
Ê Insert the air duct, see
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
66
"Inserting air duct" on page
81.
Options Guide
PCI slots
81.
RX300 S4