Note: Make sure Auto Cut is set to Off when you use the auto take-up reel.
1. Press the
load/remove paper button on the printer.
2. Select Use Take-up Unit and press the OK button.
Paper automatically feeds until the edge of the roll media reaches the roll core.
3. Wind the edge of the media around the front of the roll core.
4. Tape the edge of the media to the center of the core, then tape the edge to the left and right ends.
5. Press the right arrow button on the printer.
6. Make sure the Auto switch on the take-up reel is in the Off position and press the OK button on the
printer.
65