Adjustment Of Hook Oil Amount; Shuttle Connection / Disconnection And Oil Wick Piping - JUKI AMS-210EN Series Engineer's Manual

(12) Adjustment of hook oil amount

Standard Adjustment

(13) Shuttle connection / disconnection and oil wick piping

Procedures of disassembling
1. Loosen the three set screws .
2. Cut the harness bands .
3. Remove the set screw and pull the oil tank in the direction of the arrow A.
4. Pull Part B upwards of the two lubrication pipes and . Take them out of the oil tank .
5. Release the clamp of the oil drain pipe .
6. Loosen the set screw and take out the driver .
7. Loosen the set screw .
8. Remove the set screw and pull out the shuttle race adjust shaft
.
9. Pull the shuttle in the direction of the arrow C and take it out.
C
B
D
E
A
– 23 –