Dipswitch Setup - JUKI AMS-210EN Series Engineer's Manual

(2) Dipswitch setup

SDC board
MAIN board
IP-420 Panel Board
SW2: DIP SW2
<Normal setting state>
1-1: OFF Disabling switch for the
media detector switch
1-2: OFF (* Always used in OFF position)
(Caution) 1. If the panel cannot be used due to an
error of media cover open caused as a
result of media cover destruction or the
like, the media detector switch can be
disabled by turning this switch ON
1. All dipswitches on the SDC board are turned OFF.
2. All dipswitches on the MAIN board are turned OFF.
SW1: DIPSW 1 (for production check)
<Normal setting state>
1-1: ON
1-2: ON
1-3: OFF
1-4: OFF
(Caution) 2. Do not change the settings normally.
– 163 –